Kit Assembly - Metra 108-TO1 Instrucciones De Instalación

Note: For steps 1 and 2, reference the
installation manual provided with the radio
for which hardware to use. The display
screen and radio chassis use two different
types of screws.
1. Secure the radio brackets to the radio
chassis using (4) screws supplied with
the radio. (Figure A)
2. Secure the radio display to the radio
brackets using (4) screws supplied with
the radio. (Figure B)
3. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
4. Slide the radio assembly into the dash.
Place the radio trim panel over the radio
assembly, then secure both using the
factory screws. (Figure C)
5. Reassemble the dash in reverse order of
disassembly to complete the installation.
6

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
|
1.800.221.0932 MetraOnline.com