Installation; Notes On Safety For The Installation; Handling; Preliminary Checks - Riello RX25 S/PV H Instrucciones De Instalación, Montaje Y Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5

Installation

5.1

Notes on safety for the installation

After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
The installation of the burner must be carried out
by qualified personnel, as indicated in this manual
and in compliance with the standards and regula-
tions of the laws in force.
WARNING
5.2

Handling

The packaging of the burner includes a wooden platform, so it is
possible to move the burner (still packaged) with a transpallet
truck or fork lift truck.
The handling operations for the burner can be
highly dangerous if not carried out with the great-
est attention: keep any unauthorised people at a
distance; check the integrity and suitableness of
WARNING
the available means of handling.
Check also that the area in which you are working
is empty and that there is an adequate escape
area (i.e. a free, safe area to which you can quick-
ly move if the burner should fall).
When handling, keep the load at not more than
20-25 cm from the ground.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
CAUTION
carefully clean all around the area where the burn-
er will be installed.
5.3

Preliminary checks

Checking the consignment
After removing all the packaging, check the integ-
rity of the contents. In the event of doubt, do not
use the burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must not
be abandoned as they are potential sources of
danger and pollution; they should be collected
and disposed of in the appropriate places.
Installation
Checking the characteristics of the burner
R.B.L.
D
I
G A S
X
2R
I
G A Z
3P
R IE LLO S.p.A. I-37045 Legna go(VR )
D10487
Check the identification label of the burner, showing:
 the model A) (Fig. 3) and type of burner B);
 the year of manufacture, in cryptographic form C);
 the serial number D);
 the electrical supply data E);
 the electrical power consumption F);
 the types of fuel used and the relative supply pressures G);
 the data of the burner's minimum and maximum output pos-
sibilities H).
The burner output must be within the boiler's firing
rate;
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
and makes any installation or maintenance work
WARNING
difficult.
5.4

Generator plate

Pierce the closing plate of the combustion chamber, as in Fig. 4.
The position of the threaded holes may be marked using the gas-
ket joint supplied with the burner.
D10792
9
GB
A
B
E
G
H
G
H
11
C
F
....
Fig. 3
Fig. 4
20030020

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Rx70 s/pv h2003005020026958

Tabla de contenido