Initial Start-Up; Transportation, Installation; Removing Transportation Safeguards - Bosch EPS 815 Manual Original

4.

Initial start-up

!
The EPS 815 is only to be assembled, connected and
commissioned by specialist personnel.
4.1

Transportation, installation

Danger: Risk of injury from inexpert han-
dling of the EPS 815
Improper handling of the EPS 815 could lead
to injuries resulting from falling or tipping-up
of the unit.
¶
Wear safety shoes.
¶
Always use suitable transportation and
lifting equipment with an adequate load-
bearing capacity.
¶
Observe the center of gravity (refer to
center of gravity symbol).
¶
Always secure at the specified lashing
points when moving with a crane and lift-
ing equipment.
¶
Never stand beneath suspended loads.
A
B1
A1
B2
B
A Crane (hoisting gear)
A1 Round steel bars
A2 Base support on the cables with paint protection
A3 Rotate into a favourable transportation position
B With fork lift truck
B1 Symbol for centre of gravity
B2 Place board (1000 x 700 x 25 mm) under the test bench to pro-
vide forks with a level support surface
Robert Bosch GmbH
A3
A2
A1
Initial start-up | EPS 815 | 11
Install the test bench on a solid and level floor using the
enclosed felt pads and align with a spirit level. The up-
per edge of the oil pan is the reference point.
4.2

Removing transportation safeguards

1. By removing the upper covers (on the left and right)
and the 4 bolts with the red spacer sleeves (1).
1
2. Open the switch cabinet door and remove the fastening
screw (1) with the transportation lock marked red.
5 4
en
458735/10
1
2
|
1 689 989 348 2017-07-01