gala gar GALAXY 3000 GE MV VRD Manual Técnico De Instrucciones página 25

GALAXY 3000 GE MV VRD REF. 44000000
Brand Symbol
O
P
Q
R
O / I
S
3.1.2. REMOTE CONTROL - MD1.
Symbol
Brand
M1
M2
----
M3
The remote control connection will be carried out through connector "P" situated on the front of the
equipment.
The equipment will automatically recognise the remote control connection "M3", and LED "F" will light up,
leaving the encoder "G" disenabled.
During the "Remote" working mode, the display "L" will maintain the regulation process from the remote
control encoders "M1 and M2". To enable control "G" again, just disconnect remote control "M3", and the
LED "F" will go out.
GALAXY 3000 GE MV VRD
Description of use.
Panel connector 35/50 - Welding circuit connection. Negative pole.
Panel connector - Connection of remote control connector.
Panel connector 35/50 - Welding circuit connection. Positive pole.
Cable - Power supply input.
Switch - Welding equipment start-up. ON / OFF
Description of use.
Control potentiometer (Coarse mode) of the welding current value. It
incorporates a graduated dial on the rear of the device.
MAINS Min. 1 2
3 Ph 12 15 55
1 Ph 12 15 45
Welding current control potentiometer.
Control: FINE mode +5A ÷ -5A
Remote control connector. You must connect this to the "P" connector of
machine front panel.
MD-1 REF. 44012058
3 4 5 6
100 125 150 175
70 90 105 120
EN
M1 M1
M2 M2
M3 M3
7 8 9 Max.
205 240 285 300
140 160 190 200
24