Connecting The Power Cord (2) - Pioneer AVIC-HD3II Manual De Instalación

Section
02 Connecting the System

Connecting the power cord (2)

Speed detection circuit lead
Vehicle injection
computer
Connection method
Pass the extension
cord and the lead for
the speed detection
circuit through this
hole.
Light green
Used to detect the ON/OFF status of the handbrake. This lead must be
connected to the power supply side of the handbrake switch.
If this connection is made incorrectly or omitted, certain functions
of your navigation system will be unusable.
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
HANDBRAKE SWITCH. IMPROPER CONNECTION OR
USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW
AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
12
Engb
Pink (CAR SPEED SIGNAL INPUT)
Connector
The mobile navigation system is connected here to detect the
distance the vehicle travels. Always connect the vehicle´s speed
detection circuit or the ND-PG1 speed pulse generator, sold
separately. Failure to make this connection will increase errors in
the location display.
WARNING
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE
OR INJURY INCLUDING ELECTRICAL SHOCK, AND
INTERFERENCE WITH THE OPERATION OF THE VEHICLE´S
ANTILOCK BRAKING SYSTEM, AUTOMATIC GEARBOX AND
SPEEDOMETER INDICATION.
CAUTION
· It is strongly suggested that the speed pulse wire be connected for
accuracy of navigation and better performance of interlock.
· If the speed pulse wire is unavailable for some reason, it is
Clamp firmly
recommended that the pulse generator (ND-PG1) be used.
with needle-
nosed pliers.
Note
The position of the speed detection circuit and the position of the
Close the cover.
handbrake switch vary depending on the vehicle model. For details,
consult your authorised Pioneer dealer or an installation professional.
Connection method
Clamp the handbrake switch
power supply side lead.
Clamp firmly with needle-nosed
pliers.
5 m
Power supply side
Earth side
Handbrake switch