Introduction; Process Overview - FujiFilm SonoSite S Serie Configuración De Una Conexión A La Red

Introduction

To connect to a network (using either a wireless adapter or a LAN connection) from the SonoSite Edge,
SonoSite Edge II, SonoSite S Series, SonoSite SII, SonoSite M-Turbo, or SonoSite NanoMaxx ultrasound
system, FUJIFILM SonoSite recommends using the network setup described in this document.
Use the setup instructions from the router manufacturer for general information only.
Note

Process overview

Step
1a For a wireless connection, install
a wireless dongle or adapter.
or
1b For a LAN connection, connect
an Ethernet cable.
2a To configure the system to work
with DICOM, follow the
installation and configuration
steps in...
or
2b To configure the system to work
with PDAS (through DICOM),
follow the installation and
configuration steps in...
or
2c To configure the system to work
with SiteLink, follow the
installation and configuration
steps in...
For more information about any FUJIFILM SonoSite ultrasound system, see the appropriate ultrasound
system user guide.
2
For detailed information about connecting the SonoSite X-Porte ultrasound
system to a network and configuring it to a DICOM server, refer to the
SonoSite X-Porte User Guide.
Refer to this document
1a
"Connecting to a network"
on page 4.
or
1b The "Preparing the system"
section of your ultrasound
system user guide.
2a Sending and Receiving DICOM
Data on SonoSite, Inc. Systems
or
2b The Patient Data Archival
Software (PDAS) User Guide
or
2c The SiteLink Image Manager User
Guide
Introduction