Final Installation - Harbor Breeze RLG52NWZ5L Manual Del Usuario

FINAL INSTALLATION

1. Temporarily lift canopy (B) to mounting bracket (C)
to determine which two canopy mounting screws (O)
in mounting bracket (C) align with slotted holes in
canopy (B) and partially loosen these two canopy
mounting screws (O). Remove the other two canopy
mounting screws (O) along with star washers (E).
Now, lift canopy (B) to mounting bracket (C) again,
aligning slotted holes in canopy (B) with loosened
canopy mounting screws (O) in mounting bracket (C).
Twist canopy (B) clockwise to lock. Re-insert the
two canopy mounting screws (O), along with star
washers (E), that were just removed and tighten all
canopy mounting screws (O) securely.
2.
Partially insert three blade screws (AA) along with
three blade washers (BB) into holes in blade (G) to
attach blade arm (H) to blade (G). Then, tighten
each blade screw (AA) starting with the one in the
middle.
Repeat Step 2 for remaining blades (G) and blade
arms (H).
Hardware Used
AA
Blade Screw
BB
Blade Washer
3.
Attach blade arms (H) to the bottom of motor
housing (D) with motor screws (J) and lock
washers (K) previously removed (Step 5, page 8).
Tighten motor screws (J) securely.
NOTE: Make sure to completely secure each
blade arm (H) before proceeding to the next.
1
2
BB
x 15
x 15
3
K
J
J
14
AA
H
D
G
G
H