Fig.5 - BH FITNESS H8705 Manual Del Usuario

keys to select the desired option (55%,
75% 90% or THR) and press the
ENTER key. The first three represent
the percentage
maximum heart rate (220-age) and the
fourth is used to specify the target heart
rate manually. In the first three cases,
the lower window on the display
(TARGET H.R) will show you the
calculated value for your maximum
heart rate level. If you choose THR then
you should use the ▲/▼ keys to select
the desired heart rate and then press
ENTER. Press START/STOP to start
the exercise. The exertion level will
adjust automatically in accordance with
the selected hart rate value. If the pulse
rate is below the target value then the
exertion setting will increase by one
level every 30 seconds until it reaches
the maximum 16. If the pulse rate is
above the target value the monitor will
give out warning beeps and reduce the
exertion settings by one level every 15
seconds until it reaches the minimum 1.
If the pulse rate still stays above the
target value for more than 30 seconds
the monitor will beep and stop in order
to protect the user.
To program time, distance, calories
and/or pulse rate, go through the
following procedure: Once the heart rate
program has been selected and before
pressing the START/STOP key, press
the ENTER key to program the time limit
using the ▲/▼ keys. Press ENTER
again to program the distance. Press
the ENTER key one last time to
program the
START/STOP to start the exercise.
Your hands must be placed on the
pulse sensors (R) when using these
programs.
with respect
calories. Press
HAND-GRIP
REMENT
USE.-
to
PULSE Hand-grip.
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig.2.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
If both hands are not placed correctly
as shown in Fig.3 then the pulse
function will not work.
If a «P» appears on the screen or the
heart symbol does not flash, make
sure that both hands are placed
correctly on the sensors.
TELEMETRIC PULSE RATE.-
The monitor is equipped to receive
signals
measurement system.
The system comprises of a receiver
(D) and a transmitter (chest band)

Fig.5.

This telemetric pulse rate system
takes precedence over the Hand-
grip pulse rate system when both
are used together.
(See telemetric pulse rate instruction
book).
TEST MEASUREMENTS:
FITNESS.-
This electronic device is equipped with
a recovery test function. This offers
you the advantage of being able to
measure how long it takes your heart
12
PULSE MEASU-
INSTRUCTIONS
from a telemetric
–
pulse