BH FITNESS H8705 Manual Del Usuario página 51

use, a chlorine solution similar to that
approved for pool swimming may be
used. Please
disinfecting compounds, they may
cause permanent damages to the
transmitter.
transmitter should be cleaned by
water or soap solution to avoid allergic
reactions on skin.
- After using, clean and dry your unit
carefully. A weak signal can be due to
dirt.
- Do not expose your band to
excessive heat or cold.
- Do not leave your unit exposed to
direct sunlight or in your car.
- Keep your unit in a well ventilated
place.
Note. Never use abrasives and other
chemicals as
permanent damages to the electrodes
decreasing conductivity or durability.
Storing of transmitter. It is highly
recommended to store transmitter in
cool and dry place to maximise the
battery life. Before storage all moisture
should be wiped off.
FREQUENTLY ASKED
QUESTIONS AND ANSWERS.-
Question 1: Heart rate readings take
a long time to appear.
Answer 1:
If the heart
appearing after you start perspiring,
this is an indication that the transmitter
electrodes weren't
properly prior to commencing the
exercise.
Question 2: If there is no heart rate
reading, please check the following
things:
avoid untested
After disinfecting,
they may
rate readings
initially wetted
Answer 2:
a) The transmitter should be placed on
the rib cage just below the breasts
with the word "Polar" facing out,
reading right side up.
b) With the transmitter in position and
reasonably tight around the chest of
the user, pull the transmitter away
from the body and wet the electrodes
with water, saliva, contact solution or
other saline solution.
c) If the readings still fail to appear,
please have someone else try the
transmitter on and see if that person
can get it to work.
d) The following medical conditions
may create problems:
•Premature ventricular contractions,
tachy-cardia bursts, and arrythmias
can result in strange or no heart rate
cause readings.
•If the customer has an implanted
medical device such as a pacemaker,
you must consult your physician prior
to using the Polar Transmitter.
e) The ECG signal perceived by
transmitter is too weak for successful
measure-ment. Heart diseases, heart
surgeries or natural characteristics of
a heart mayresult in weak ECG
signals. In many cases, where a weak
ECG
problems, the reliable operation can
be obtained by moving transmitter a
little bit to the left or right. Remember
start
to rewet electrodes.
f) Electromagnetic interference. Polar
transmission can be affected by high
power transmission lines or other such
devices
magnetic fields located in the area of
equipment usage. If someone of your
associates has a Polar heart rate
monitor, if possible, borrow it for a
while to check that unit works properly
51
signal is the
that generate
reason for
powerful