Important User Information - Peltor ComTac XP MT17H682FB Serie Manual Del Usuario

EN
MT17H682FB-** **
This active-volume hearing protector from Peltor is specially designed to be
worn comfortably under a helmet or while using various guns, and still give
effective protection against harmful noise. The standard model has an audio
input for connecting an external radio, and an active-volume function that
amplifies weak sounds and attenuates loud ones. The external communication
and active-volume functions are independent of each other, which ensures
extra good reliability and better safety. The hearing protector has been tested
and approved according to PPE directive 89/686/EEC and EMC directive
89/336/EEC, which means that it meets the demands for CE labelling.
Read these instructions carefully to ensure the best possible benefit from your
new Peltor product.
FUNCTIONS (A)
Functions: Volume, Plug Mode, Balance mode, EQ mode, External mute
mode, Release time mode.
• The latest settings are stored at shut-off. However, not Plug mode.
• Automatic shut-off after two hours of no active functions. Two warning signals
are emitted to indicate that the unit will switch off in one minute if no function
is activated.
• The battery life span is about 500 hours. Three warning signals are emitted
every 30 seconds for five minutes when battery power is low. After this, the
unit switches off.
WARNING! Sound reproduction may deteriorate as the batteries wear.
• Polarity protection prevents damage to circuits if the batteries are inserted
incorrectly.
• Equipped with an audio input via a chassis jack for connecting an external
radio. You can listen to an external signal without battery power and even
when the product is switched off.
(A) WHAT IS WHAT
. Headband wire
. Two-point fastener (guide wire)
3. Ear cushion
4. Microphone for active volume
5. Attenuation cushion
6. Battery cover
7. Shell
8. Headband
9. Audio input
0. On/off and volume control
. Speech microphone/bone-conduction microphone for headset versions
With permanent connector cord.
Note that the microphone connects to the audio input jack.
For maximum ambient-noise compensation, position the speech
microphone on the headset no less than 3 mm from the lips.

IMPORTANT USER INFORMATION

The hearing protector must be put on, adjusted, cleaned and maintained in
accordance with the instructions in this manual.
• This hearing protector has an active-volume function. The user should check
that this function is switched on before using. If something doesn't sound
right or if flaws are discovered, the user should turn to the manufacturer for
advice on care and battery replacement.
• Wear the headset 00% of the time you spend in noisy environments for full
protection.
• Certain chemical substances may be harmful to this product. Contact the
manufacturer for more information.
• When interference increases or the volume becomes too weak, it is time to
replace the batteries. Never replace or install batteries with the unit switched
on. Ensure that the battery is positioned correctly before using. See the
figure in the CARE section.
• Do not store with the batteries installed.
• In extremely cold conditions, warm up the hearing protector before use.