Setting Up 535A Close Coupled To 141 Geared Threader - RIDGID 141 Manual De Instrucciones

Model 141/161 Receding Geared Threaders
No. 844 Drive Bar
Set Screw (2)
141 Geared Threader
Figure 15 – 844 Drive Bar and 768 Drive Link Installed
Figure 16 – Saddle on 535 Carriage
4. Align the post of 768 drive link with the die head
mounting hole in the carriage and fully insert by mov-
ing the carriage. Tighten the drive link set screw to hold
in place. Make sure that the geared threader and
threading machine are stable and secure (Figure 17) .
5. On machines with oiling systems, install the flexible oil
spout on drive link and route so nozzle applies oil
between chaser #1 and 2.
12
Drive
Shaft
768 Drive
Link
Figure 17 – Geared Threader Close-Coupled To 535
Set Screw
Attachment
Boss
Leveling
Saddle
Figure 18 – Flexible Oil Spout Routing
Setting up 535A Close Coupled to 141
Geared Threader
1. Place the leveling saddle on the carriage as shown in
2. Install the flexible oil spout on 268 drive link.
3. Loosen set screw in geared threader attachment
4. From the rear of machine, install the drive bar through
5. Using at least two people or appropriate equipment, lift
Figure 16.
boss.
the spindle tube to the cover (jaws must be fully
open). A counterclockwise rotation of the drive bar is
required.
the geared threader, and place on the leveling saddle
with the driveshaft of the geared thread lined up with
the driveshaft in the threading machine.
Oil Spout
Between Dies
1 and 2