ELICA NIKOLATESLA LIBRA WH/A/83 Montaje Y Modo De Empleo página 65

USING THE EXTRACTOR FAN
Power-on
Press (touch) ON/OFF hob/ extractor
The indicator light will turn on to indicate that the hob/extractor
is ready for use
Press again to turn off
Note: This function has priority over the others.
Switching on the extractor fan:
Touch (press) the selector
Extraction speed (power):
touch (press) the selector
speed (power) (0-10);
touch (press) the selector
speed (power) (10-0);
Timer
The Timer is activated at any speed by pressing the symbol
display (10) will show the countdown
display (8) will show the symbol
Extractor fan Timer regulation
The preset shut-down times can be modified. The variation
must be made when the Timer is active.
• Press to increase the automatic shut-down time
• Press to decrease the automatic shut-down
time
Filter saturation indicator
The hood indicates when filter maintenance is needed:
Grease filter
" "
the (11) LED lights up
Activated carbon odour filter
" "
the (11) LED flashes
to activate the extractor fan
to increase the extraction
to decrease the extraction
Reset filter saturation
After carrying out maintenance on the filters (grease and/or
activated carbon) hold down the
" "
the LED turns off and the count restarts.
Activation of activated carbon odour filter saturation
indicator
This indicator is normally deactivated.
To activate it, proceed as follows:
- turn on the aspiration hob by pressing
- with the aspiration motor and cooking zones off, press and
hold ;
" "
- turns on, then off to indicate successful
activation.
Deactivation of activated carbon odour filter saturation
indicator
repeat the activation steps described above
" "
flashes, then turns off to indicate successful
deactivation.
Automatic mode
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
Once the hob is turned off, the hood adapts its aspiration
speed, gradually decreasing it, so as to eliminate residual
vapours and odours
To activate this function:
Briefly press , the LED "
that the hood is working in this mode.
Automatic hood mode with SNAP
For information on how to make the connection between the
hood and SNAP see the manual supplied with SNAP
®,
visit www.elica.com.
Note: SNAP is an auxiliary extraction unit able to operate at
®
the same time as the hood.
To activate this function:
Briefly press , the LED "
will light up to indicate that the hood is working in this mode.
64
key;
;
" (11) will light up to indicate
®
®
" and the LED SNAP (11)
or