Ialing A Stored Number; Inserting A Pause In The Dialing Sequence - GE SPACEMAKER 26976 Guia Del Usuario

3. Press the mem button to store the number. You will hear a
confirmation tone.
To replace a number stored in a memory location with a redial number:
1. Repeat steps 1 through 2 in Storing a Redial Number
2. Press the mem button and REPLACE MEMO? shows in the display.
3. Press TONE*/exit to exit, or press the memory button again and the
redial number replaces the old number in that memory location. You
will hear a confirmation tone.
D S
IALING A
1. Make sure the phone is ON by pressing the TALK/CALLBACK button.
2. Press mem button.
3. Press the number (0-9) for the desired memory location. The number
dials automatically.
OR
1. Make sure the phone is OFF (not in TALK mode).
2. Press mem button.
3. Use the CID/VOL (-) arrow or CID/VOL (+) arrow button to scroll through
the numbers stored in memory until the desired number is shown.
4. Press TALK/CALLBACK. The numbers dial automatically.
IMPORTANT: If you make test calls to emergency numbers stored in
memory, remain on the line and briefly explain the reason for the
call to the dispatcher. Also, it's a good idea to make these calls in off-
peak hours, such as early morning or late evening.
I
NSERTING A
When storing information in memory, press the # pause button twice
within one second to insert a delay in the dialing sequence of a stored
telephone number when a pause is needed to wait for a dial tone (for
example after you dial 9 for an outside line, or to wait for a computer
access tone). Pause shows on the display as a "P . " Each pause counts as
1 digit in the dialing sequence.
38
N
TORED UMBER
P
AUSE IN THE
D S
IALING EQUENCE