Installing The Handset Attery; Connecting The Telephone Line; Onnecting The Ac; Prior To Use - GE SPACEMAKER 26976 Guia Del Usuario

C
ONNECTING THE
1. Connect one end of the telephone line cord to the LINE jack on the
bottom of the wall base unit.
2. Connect the other end of the telephone line cord to a telephone jack
on the wall.
3. Raise the antenna on the base.
Connect to any other phone
C
ONNECTING THE
1. Plug the wall base unit into an electrical outlet.
2. Make sure that its pins are inserted fully into the outlet and it is firmly
installed. If not, choose another electrical outlet to plug into.
I
NSTALLING THE
NOTE: The handset battery and battery compartment cover are
packaged together.

PRIOR TO USE

PRESS DOWN
FIRMLY
CHARGE FOR 12 HOURS
1. Connect the battery cord into the jack inside the handset battery
compartment and then insert the battery pack.
NOTE: It is important to maintain the polarity (black and red wires)
to the jack inside the compartment as shown in the illustration. For
this purpose and your convience the battery plug and jack are keyed
so they will only mate in one direction.
2. Close the battery compartment by pushing the cover up until it snaps
into place.
T
ELEPHONE
AC (E
LECTRICAL
H
ANDSET
CONNECT BATTERY AND
INSTALL COVER
BATTERY
BLACK WIRE
L
INE
) P
OWER
B
ATTERY
RED
WIRE
9