Speakerphone Operation; Speakerphone Location; Speakerphone Guidelines; Registration - GE SPACEMAKER 26976 Guia Del Usuario

S
PEAKERPHONE
S
PEAKERPHONE
For best speakerphone performance, avoid the following:
• Areas with high background noise. (The microphone might pick up
these sounds and prevent the speakerphone from going into the
receiving mode when you finish talking.)
• Surfaces affected by vibration.
• Recessed areas such as in a corner, in a cupboard, or next to a cabinet,
which can generate an echo effect.
S
PEAKERPHONE
• The speakerphone works similar to a two-way radio, you can only
listen or talk at one time.
• Stay reasonably close to the phone so that you can be clearly heard by
the person to whom you are talking.
• Press the speaker button to turn on the speakerphone.
• Press the CID VOL(+) or CID VOL(-) arrow button on the Spacemaker®
Unit to adjust the speakerphone listening level. You will hear a tone
when you reach the minimum or maximum volume level.
R
EGISTRATION
The Spacemaker® Unit is pre-registered to the wall base unit.
If your Spacemaker® Unit is properly connected, but you cannot hear a
dial tone when pressing the SPEAKER button, it may not be properly
registered. Then, follow these steps to re-register the Spacemaker® Unit
to the wall base unit:
1. Move the Spacemaker® Unit close to the wall base unit or vice versa.
2. Make sure both the handset and the Spacemaker® speakerphone are
OFF (not in TALK mode).
3. Press and hold the format button on the Spacemaker® Unit until you
hear a beep and PRESS AND HOLD BASE PAGE KEY shows in the
display.
4. Press and hold the page button on the wall base unit.
NOTE: You must press the page button on the wall base unit within
30 seconds to continue registration.
O
PERATION
L
OCATION
G
UIDELINES
27