Andset Sound Signals; Eadset And; Onnecting An Optional; Headset To Theh - GE SPACEMAKER 26976 Guia Del Usuario

UNKNOWN NAME/ The incoming call is from an area not serviced by
CALLER/NUMBER
PAGING
BLOCKED CALL
BLOCKED NAME
REPT
NO DATA
EMPTY
NO CALLS
H S
ANDSET
Signal
A long warbling tone
(with ringer on)
Two long beeps
One short and one long beep
One short beep
every seven seconds
H

EADSET AND

C
ONNECTING AN
For hands free conversation, connect the headset (optional) to the
HEADSET jack as shown. The handset receiver and microphone are
disabled when the headset is connected.
TIP: To order a headset, please refer to the accessory order form at the
end of this user's guide.
Adjust the headset to rest comfortably on top of
your head and over your ear. Move the
microphone to approximately 2 to 3 inches from
your mouth.
• Press the TALK/CALLBACK button to answer
or place a call before using the headset.
Caller ID or the information was not sent.
Someone has pressed the page button on the base.
The call information is blocked from transmission.
The caller's name is blocked from transmission.
Repeat call message. Indicates that a new call from
the same number was received more than once.
No Caller ID information was received.
Indicates a memory location is vacant.
Indicates no CID records have been stored.
S
OUND IGNALS
B C
ELT LIP
O
PTIONAL
Meaning
Signals an incoming call
Confirmation Tone
Page signal
Low battery warning
O
PERATION
H
EADSET TO THE
H
ANDSET
headset jack
REDIAL CID/VOL FORMAT
F
- +
timer mem
TALK M
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
exit
0 9
TONE * OPER PAUSE
delete ringer program
HI
LO
CHAN FLASH
OFF
mic
headset plug
43