Section
04
Installation
Installing the navigation
system
Installation notes
! Do not install the navigation system in
places subject to high temperatures or hu-
midity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be exposed to rain,
such as close to the door or on the vehi-
cle's floor.
! Install this navigation system in an area
strong enough to bear its weight. Choose a
position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.
! Install the navigation unit horizontally on a
surface within 0 degrees to 30 degrees tol-
erance (within 10 degrees to the left or
right). Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors in
the location display, and might otherwise
cause reduced display performance.
30°
10°
12
Engb
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
! The semiconductor laser will be damaged
if it overheats, so don't install the naviga-
tion unit anywhere hot —for instance, near
a heater outlet.
! Do not install this navigation system where
it is difficult to remove the detachable de-
vice from the head unit or open the drawer
due to being encumbered by the gear stick
or any other objects. Before installing this
navigation system, be sure to leave suffi-
cient space so that the detachable device
or the drawer does not prevent the opera-
tion of the gear stick when the detachable
device is detached or the drawer opened.
Otherwise, these may cause interference
with the gear stick, or a malfunction of the
detaching mechanism.
10°
5 cm
10 cm
Leave ample space
9 cm to 10 cm
Dashboard