Stihl FS 160 Manual De Instrucciones página 71

B
3
Position the support so that
N
distance (B) between it and the
clutch housing (5) is about 24 cm.
Now tighten down the seven
N
mounting screws on the support
firmly.
FS 160, FS 220, FS 280, FS 290
Mounting the control handle
5
Take out the screw (6) – the nut (7)
N
remains in the control handle (8).
Push the control handle onto the
N
handlebar (4) until the holes (10)
line up – the throttle trigger (9) must
point towards the gearbox.
Insert screw and tighten it down
N
firmly.
Fitting the throttle cable retainers
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
14
16
13
15
13
Press one throttle cable
N
retainer (13) into the upper
hole (14) and one into either of the
lower holes (15).
Press the third retainer (13) into the
N
hole (16) in the clutch housing cap.
Adjusting the throttle cable
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
English
13
69