Stihl FS 160 Manual De Instrucciones página 90

English
Fine tuning with mowing head
The mowing lines must extend as far as
the blade on the deflector.
Carry out the standard setting.
N
Warm up the engine for
N
about 1 minute at full throttle, then
return to idling speed.
Turn the high speed screw (H) a 1/2
N
turn counterclockwise.
Open the throttle wide.
N
At high altitude
Turn the high speed screw (H)
N
clockwise (leaner) until there is no
further noticeable increase in
engine speed.
Turn the high speed screw (H) 1/8
N
turn counterclockwise.
At sea level
Turn the high speed screw (H)
N
counterclockwise (richer) until there
is no further noticeable increase in
engine speed.
It is possible that maximum engine
speed may be reached with the standard
setting.
Fine tuning with metal cutting
attachment
NOTICE
This adjustment may only be performed
by trained personnel with the aid of a
tachometer. STIHL recommends a
STIHL servicing dealer.
88
Carry out the standard setting.
N
Warm up the engine for
N
about 1 minute at full throttle, then
return to idling speed.
Turn the high speed screw (H) a 1/2
N
turn counterclockwise.
Open the throttle wide and turn the
N
high speed screw (H) slowly
clockwise until the maximum
permissible engine speed of
12,500 rpm is reached.
NOTICE
Turning the high speed screw any
further clockwise makes the fuel-air
mixture too lean – risk of engine
damage.
If maximum engine speed and full power
cannot be achieved, ask your servicing
dealer for assistance. STIHL
recommends a STIHL servicing dealer.
Adjusting Idle Speed
L
LA
After every correction to the low speed
screw (L):
It may be necessary to change the
–
setting of the idle speed screw (LA).
It may be necessary to change the
–
setting of the high speed screw (H).
Warm up the engine.
N
Engine stops while idling
Carry out standard setting on low
N
speed screw (L).
Turn the idle speed screw (LA)
N
slowly clockwise until the engine
runs smoothly – the cutting
attachment must not turn.
Cutting attachment rotates when engine
is idling
Turn the idle speed screw (LA)
N
counterclockwise until the cutting
attachment stops moving and then
rotate the screw another 1/4 to 1/2
turn in the same direction.
WARNING
If the cutting attachment continues to run
when the engine is idling, have your
machine checked and repaired by your
servicing dealer.
Erratic idling behavior, poor
acceleration, engine stops even though
setting of LA-screw has been corrected
Idle setting is too lean:
Carry out standard setting on low
N
speed screw (L).
Turn the low speed screw (L)
N
counterclockwise until the engine
runs and accelerates smoothly.
Erratic idle speed, exhaust smokes at
idle speed
Idle setting is too rich
FS 160, FS 220, FS 280, FS 290