Stihl FS 160 Manual De Instrucciones página 79

4
3
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
Fit the thrust washer (2) – convex
N
side must face up.
Fit the rider plate (3) (for mowing
N
applications).
Block the shaft.
N
Screw the mounting nut (4) on to the
N
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
FS 160, FS 220, FS 280, FS 290
NOTICE
Remove the tool used to block the shaft.
Removing the cutting attachment
Block the shaft.
1
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
mounting hardware off the gearbox.
Shredder Blade 270-2
Mounting the cutting attachment
Fit the guard ring for mowing
N
applications.
4
2
b
b
a
Place the shredder blade (1) in
N
position – the cutting edges must
point upwards.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
N
N
N
N
If the mounting nut has become too
loose, fit a new one.
Remove the tool used to block the shaft.
3 3
Removing the cutting attachment
1
N
N
N
WARNING
Fit the thrust washer (2) – convex
side must face up.
Fit the guard ring (3).
Block the shaft.
Screw the mounting nut (4) on to the
shaft counterclockwise and tighten
it down firmly.
WARNING
NOTICE
Block the shaft.
Unscrew the mounting nut
clockwise.
Pull the cutting attachment with its
mounting hardware off the gearbox.
English
77