Mounting The Bike Handle - Stihl FS 160 Manual De Instrucciones

Fit the center screw, but do not
N
tighten it down yet.
Insert the two M5x20 screws
N
provided and tighten them down
firmly.
Push the cap (5) over the sleeve so
N
that the opening (12) lines up with
the tapped hole (10) in the sleeve.
Tighten down the center screw in
N
the sleeve (7) firmly.
FS 160, FS 220, FS 280, FS 290

Mounting the Bike Handle

FS 160 – Mounting bike handle with
fixed handle support
The fixed handle support is supplied
separately and must be mounted to the
drive tube.
Mounting the handlebar
6 6
5
1
4
A
2
Mount the handlebar (1) on the
N
drive tube (2) about 40 cm (A)
forward of the engine housing.
Place the clamp (3) and handle
N
support (4) against the drive tube.
Fit the handlebar (1) in the handle
N
support – the rubber handle must be
on the left (viewed from the engine).
Place the clamp (5) on the handle
N
support.
Insert the screws (6) through the
N
holes in the parts and screw them
into the clamp (3) as far as stop.
Line up the handlebar.
N
Tighten down the screws firmly.
N
Mounting the control handle
9
8
3
Take out the screw (7) – the nut (8)
N
remains in the control handle (9).
Push the control handle onto the
N
handlebar (1) until the holes (11)
line up – the throttle trigger (10)
must point towards the gearbox.
Insert screw and tighten it down
N
firmly.
English
10
11
7
1
11
67