Specifications For Gf100 Series Devices - Brooks Instrument GF100 Serie Manual De Instrucciones

Section 1 Introduction
GF100 Series

1-11 Specifications for GF100 Series Devices

1-8
Communication Interfaces
The GF100 Series supports analog 0-5 Vdc, RS485, DeviceNet™ and
EtherCAT communication protocols. Analog connections can be accessed
®
via the DeviceNet or RS485 or Analog only connector options. DeviceNet
and RS485 are multi-drop connections that allow a maximum of 64 devices
for DeviceNet and 32 devices for RS485 to be connected on the same
network. Brooks Instrument's DeviceNet profile has been certified by the
ODVA™ (Open DeviceNet Vendor's Association). EtherCAT is an Ethernet
based communications system know for its high cycle time and cost
efficient cabling and master application solutions. The EtherCAT GF100
Series devices conform to the ETG.5003 Semiconductor Device Profile
specification. A range of low profile adapter cables facilitate replacing
previously installed devices eliminating the need to carry multiple devices
of the same gas/range but different electrical connectors.
See Table 1-3 for specifications for standard GF100 Series.
See Table 1-4 for specifications for the Safe Delivery System (SDS) GF120
Series.
See Table 1-5 for specifications for standard GF100 Series-EtherCAT
See Table 1-6 for specifications for the GF135 Series.
See Table 1-7 for specifications for the GF121 Series.
See Table 1-8 for specifications for the GF121 Series-EtherCAT
See Figure 1-3 for dimensions for the GF100 Series.
See Figures 1-4 & 1-5 for dimensions for the GF135 Series.
See Figure 1-6 for dimensions for the GF121 Series.
See Figure 1-7 for dimensions for the GF100/GF121 Series-EtherCAT
Installation and Operation Manual
X-TMF-GF100-Series-MFC-eng
Part Number: 541B137AAG
April, 2017