Brooks Instrument GF100 Serie Manual De Instrucciones página 37

Installation and Operation Manual
X-TMF-GF100-Series-MFC-eng
Part Number: 541B137AAG
April, 2017
Figure 2-10 MultiFlo Cable Adapter
Diagnostic Port
(
2.5mm jack)
Figure 2-12 Diagnostic Port Locations
Figure 2-11 USB-RS485 Converter (214F027AAA)
Connect the USB end of the converter to a laptop or PC.
For GF1xx devices with EtherCAT communication, the diagnostic port must
be used to interface with the MultiFlo Configurator.
• Ensure the M8 power connector is attached and the device is powered on
• Only after the device is powered on, attach a micro-USB cable to the
diagnostic port of the device and the USB end to a laptop or PC
• Once use of the diagnostic port is complete, remove the micro-USB cable
before removing power from the device. See Figure 2-12 below
Diagnostic Port (EtherCAT with Micro-USB)
Section 2 Installation
GF100 Series
2-11