Descargar
Compartir
Imprimir esta página
  1. Manuales
  2. Marcas
  3. Huffy Sports Manuales
  4. Deportes y Aire Libre
  5. Spalding 214994B
  6. Manual de instrucciones

Huffy Sports Spalding 214994B Manual De Instrucciones

Ocultar thumbs

Publicidad

Enlaces rápidos

Descargar este manual
© COPYRIGHT 2000 by HUFFY SPORTS
Portable System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
Read and understand
operator's manual before
using this unit.
Failure to follow operating
instructions could result
in injury or damage to
property.
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
REQUIRED TOOLS AND MATERIALS:
• Two People
• Wood Board (Scrap)
• Tape Measure
• Step Ladder 8 ft. (2.4 m)
• Tape
• Garden Hose or Sand 360 lb. (163 kg)
• Hammer
• Wrenches: (Two) 1/2", (One) 9/16" or Two Small
Adjustable Wrenches (9/16" Deep Socket
w/Extension Recommended)
• Support Table
1
05/03
P/N 214994B

Publicidad

loading

Manuales relacionados para Huffy Sports Spalding 214994B

Resumen de contenidos para Huffy Sports Spalding 214994B

  • Página 1 Recommended) • Support Table Toll-Free Customer Service Number for U.S: 1-800-558-5234, For Canada: 1-800-284-8339, For Europe: 00 800 555 85234 (Sweden: 009 555 85234), For Australia: 1-800-333 061 Internet Address: http://www.huffysports.com 05/03 P/N 214994B © COPYRIGHT 2000 by HUFFY SPORTS...
  • Página 2 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NOT HANG on the rim or any part of the system including backboard, support braces or net.

  • Página 3: Safety Instructions

    • The life of your basketball pole depends on many conditions. The climate, placement of the pole, the location of the pole, exposure to corrosives such as pesticides, herbicides or salts are all important. • If technical assistance is required, contact Huffy Sports. • Adult supervision is recommended when adjusting height.
  • Página 4 NOTICE TO ASSEMBLERS ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.
  • Página 5 Get to know the basic parts of your basketball system..FRONT BACKBOARD STRUTS POLE BASE WHEEL CARRIAGE ASSEMBLY 05/03 P/N 214994B...

  • Página 6: Parts List

    PARTS LIST - (See Hardware Identifier) Item Qty. Part No. Description 206645 Tank (Black) 200628 Wheel Axle 226401 Wheel 900060 Top Pole Section 908480 Middle Pole Section with Label 908490 Bottom Pole Section 202820 Rod, 3/8 O.D. x 4-3/4 Long 202822 Eye Bolt, 3/8 x 16 x 3-3/4 Long 200627...
  • Página 7 HARDWARE IDENTIFIER Item #7 (1) Item #8 (1) Item #10 (1) Item #11 (1) Item #14 (1) Item #12 (6) Item #16 (2) Item #17 (6) Item #19 (12) Item #21 (4) Item #22 (4) Item #23 (2) Item #28 (2) 05/03 P/N 214994B...
  • Página 8 SECTION A: ASSEMBLE THE BASE This is what your system will look like when you’ve finished this section: HARDWARE USED IN THIS SECTION TOOLS REQUIRED FOR THIS SECTION (not actual size) 9/16” and 1/2” Item #7 (1) Item #8 (1) Item #10 (1) AND/OR Item #12 (6)
  • Página 9 Remove contents from tank Correctly identify each pole section and mark indicated distance from ends with tape (not supplied) as shown. TAPE (Not Supplied) MIDDLE 5” (13 cm) BOTTOM 5” (13 cm) IMPORTANT! Center the alignment slot of middle pole section (5) in the lower hole of top pole section (4) as shown.
  • Página 10 IMPORTANT! Center the alignment slot of lower pole section (6) in the lower hole of middle pole section (4) as shown. While maintaining alignment, bounce top and middle pole assembly (4 & 5) onto bottom section of pole (6) using wood scrap as shown until they no longer move toward taped reference mark.
  • Página 11 Install wheel axle (2) through wheel carriage (9). Install wheels (3) onto wheel axle (2) with spacers (28) as shown. Insert pole assembly into tank assembly as shown. Secure bottom pole (6) to tank and wheel bracket as shown. A deep socket is recommended. IMPORTANT! DO NOT OVER TIGHTEN. WARNING! IMPORTANT!: TWO PEOPLE...
  • Página 12 Secure non-secured ends of tank struts (13) to tank as shown. Repeat for opposite side. P/N 214994B 05/03...
  • Página 13 SECTION B: ASSEMBLE THE BOARD AND RIM This is what your system will look like when you’ve finished this section: HARDWARE USED IN THIS SECTION TOOLS REQUIRED FOR THIS SECTION (not actual size) 1/2” Item #19 (12) Item #17 (6) AND/OR Item #22 (4) Item #21 (4)
  • Página 14 Mount brackets (20) and rim (18) to backboard and finger tighten as shown. NOTE: Final adjustments will be made in Step 3 of this section IMPORTANT! For spring loaded rim assembly, refer to instructions included with rim hardware. Refer To Instructions Included With Rim Hardware For Rim...
  • Página 15 Support pole and tank assembly over support table. Carefully slide backboard components onto pole. WARNING! WARNING! TWO PEOPLE DO NOT LEAVE REQUIRED FOR THIS ASSEMBLY PROCEDURE. FAILURE UNATTENDED WHEN TO FOLLOW THIS EMPTY; IT MAY TIP WARNING COULD OVER. RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
  • Página 16 Install clips. WARNING! USE OF THIS PRODUCT CLIP “ARM” WITHOUT PROPER INSTALLATION OF SMART CLIPS, OR WHEN ALL SMART CLIPS ARE NOT PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CLIP “BODY” CAREFULLY. Insert one “arm” of clip into ram as shown. Twist “body” of clip slightly so that second “arm”...
  • Página 17 NET INSTALLATION SIDE VIEW NETCLIP Insert net into bottom of clip as shown. SIDE VIEW Twist net until it snaps into position. Net must be centered through clip. NETCLIP 05/03 P/N 214994B...
  • Página 18 SECTION C: APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM Carefully upright assembly. Apply moving system label (15) to front of pole as shown. Regulation rim height is 10 feet (3.05 m). WARNING! WARNING! TWO PEOPLE DO NOT LEAVE REQUIRED FOR THIS ASSEMBLY PROCEDURE.
  • Página 19 05/03 P/N 214994B...
  • Página 20 FRENCH INSTRUCTIONS REMARQUE : Il est recommandé de s'y prendre à deux IMPORTANT ! NOTEZ À LA PAGE 1 DE CE MANUEL pour cette procédure. Redressez l'ensemble avec précaution. LE NUMÉRO DE MODÈLE MENTIONNÉ SUR LE CARTON. Collez l'étiquette de déplacement du système (15) sur l'avant du poteau, comme illustré.
  • Página 21 05/03 P/N 214994B...
  • Página 22 SPANISH INSTRUCTIONS ¡IMPORTANTE! ANOTE EN LA PÁGINA 1 DE ESTE MANUAL DEL PROPIETARIO EL NÚMERO DE MODELO QUE APARECE EN LA CAJA. Saque el contenido del tanque (1). Coloque la unidad montada en la ubicación deseada. Llene el Identifique correctamente cada sección del poste y marque con tanque con 30 galones (114 litros) de agua o con 360 libras (163 kg) de cinta la distancia indicada desde los extremos, como se muestra.
  • Página 23 05/03 P/N 214994B...
  • Página 24 GERMAN INSTRUCTIONS WICHTIG! NOTIEREN SIE SICH DIE MODELLNUMMER AUS DEM KÄSTCHEN AUF SEITE 1 DIESES BENUTZERHANDBUCHS Den Tank (1) leeren. 13. Die zusammengebaute Einheit an den gewünschten Aufstellungsort Jedes Stangenteil richtig identifizieren und den angegebenen Abstand bringen. Den Tank mit Wasser (114 l [30 US-Gallonen]) oder Sand (163 kg von beiden Enden wie gezeigt mit Klebeband markieren.