GE Profile PV970 Serie Manual Del Propietário página 15

INSTALLATION - VENTED TO THE OUTSIDE
STEP 2: INSTALL HOOD MOUNTING
SCREWS
The two upper mounting screws must enter the
horizontal support or wall studs.
mark mounting bracket screw locations.
in the lower bracket. If the bottom 2 pilot holes
install metal wall fastener anchors (provided).
WALL VENT IS 27-3/4" MIN.
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
ABOVE THE INSTALLATION
HEIGHT
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
Horizontal Line
gap between the screw head and the wall. This
will allow the keyhole slot on the hood frame to
engage the screw head.
IMPORTANT: Use the mounting screws provided.
DO NOT USE DRYWALL SCREWS.
horizontally level.
49-2000916 Rev. 0
Installation Instructions
10-1/8"
REAR WALL
MOUNTING TEMPLATE
C L
ALIGN BOTTOM EDGE
WITH PENCIL LINE
INDICATING BOTTOM
OF THE HOOD
12-1/2"
Installation Height
31-14772 Printed in Mexico 12-08 JR
STEP 3: INSTALL DUCT BRACKET
The duct bracket should be installed against the
the ceiling meets the wall should be level for the
bracket and duct cover to fit flush. This bracket will
hold the duct cover in place at the top.
Secure the bracket to the wall:
bracket with the penciled centerline on the wall.
anchors (provided).
appropriate #10 masonry screw anchors. Drill and
install per the fastener supplier's instructions.
anchors to expand. Remove the screws.
Centerline cutout
STEP 4: MOUNT THE HOOD
WARNING
2 people are required to lift and
position the hood onto the mounting screws.
in front of the flange and not behind it. Check with
a level before tightening the screws.
the wall.
Tighten screws
Bottom
Install
screw
screws
location
(Cont.)
15