GE Profile PV970 Serie Manual Del Propietário página 17

INSTALLATION - VENTED TO THE OUTSIDE
STEP 7: INSTALL DUCT COVERS
covering.
according to application.
NOTE: The inside duct cover
has vent holes on one end.
The holes are intended for
use when the hood is installed for recirculating
purposes. Slide the upper duct cover into the folded
ends of the lower duct cover.
hood.
Upper
duct cover
Lower
duct cover
Lower duct
cover seat
bracket.
opening.
the opening. Install 2 screws to secure the lower
duct cover to the hood.
49-2000916 Rev. 0
Installation Instructions
Mounting
screws
Duct cover bracket
Duct cover
attachment
tabs
Screw holes
STEP 8: INSTALL METAL GREASE
FILTER
NOTE: The charcoal filter is not required for this
installation.
the left side of the filter opening. Lift up the right
side of the filter and push gently until the filter
locks into place. Make sure the filter lock is in the
closed position to secure the filter.
lock to release.
STEP 9: FINALIZE INSTALLATION
materials have been removed.
to operate the hood.
(Cont.)
17