GE Profile PV970 Serie Manual Del Propietário página 21

INSTALLATION - RECIRCULATING
STEP 6: CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure
to use U.L. approved anti-oxidant compound and
aluminum-to-copper connectors.
and the knockout on the top left side.
Knockout
Junction
box cover
strain relief.
lead.
lead.
circuit green lead or bare ground lead.
electrical connector.
the cover. Be sure the wires are not pinched.
screws.
49-2000916 Rev. 0
Installation Instructions
(Cont.)
STEP 7: INSTALL DUCT COVERS
Remove protective plastic
covering.
Assemble duct covers
according to application.
NOTE: The upper duct cover has
vent holes on one end intended
for use when the hood is installed
for recirculating purposes. Be
the vent holes will be visible in
this installation.
Slide the upper duct cover into
the folded ends of the lower duct cover.
Place the decorative duct covers on top of the hood.
Upper
duct cover
Lower
duct cover
Lower duct
cover seat
Extend the inner duct cover upward to the ceiling
bracket.
Secure with 2 screws to the duct cover bracket.
Remove the packing material from the filter opening.
Locate the screw holes on the inside front edge
of the opening. Install 2 screws to secure the
lower duct cover to the hood.
Mounting screws
Vent holes
Duct cover
support
bracket
Duct cover
attachment tabs
Screw holes
21