Weigh Below - Uline Ohaus Adventurer H-5276 Manual Del Usuario

ITEM SETTINGS
To view or adjust the current settings, touch the
ITEM SETTINGS button. (See Figure 66) The settings
screen appears.
Filler: If set to ON, a filler material is asked for at the end
of the formulation.
Automatic Mode: If set to ON, the balance will
automatically tare after the component weight has
been accepted.
Print Settings: Change printing settings.

WEIGH BELOW

The scale is equipped with a weigh below hook for
weighing below the balance.
NOTE: Before turning the balance over, remove
the pan and draft shield elements (if present)
to prevent damage.
CAUTION! Do not place the balance on the
pan support cone or load cell pins.
To use this feature, remove power from the balance,
then remove the protective cover for the weigh below
opening. (See Figure 67)
The balance can be supported using lab jacks or any
other convenient method. Ensure the balance is level
and secure. Power on the balance, then use a string or
wire to attach items to be weighed.
CALIBRATION
Periodically verify calibration by placing an accurate
weight on the balance and viewing the result.
CLEANING
WARNING! Disconnect the balance from the
power supply before cleaning.
CAUTION! Do not use solvents, harsh chemicals,
ammonia or abrasive cleaning agents.
PAGE 17 OF 54
OPERATION CONTINUED
Figure 66
Figure 67
MAINTENANCE
Make sure that no liquid enters the interior of the
balance.
Clean the balance at regular intervals.
Housing surfaces may be cleaned with a lint-free cloth
slightly dampened with water or a mild cleaning agent.
Glass surfaces may be cleaned with a commercial
glass cleaner. Please follow the steps on page 18 on
how to remove and install the sliding doors.
Formulation
Filler Auto Tare Print Settings
Back
Weigh Below
Protective
Cover
Weigh Below
Hook
Exit
0521 IH-5276