Weigh Below Hook; Interface Commands - Uline OHAUS RANGER 7000 Manual Del Usuario

WEIGH BELOW HOOK

The Ranger 7000 Scale is equipped with a weigh below
hook for weighing below the scale.
CAUTION! Ensure scale is properly supported
so it cannot fall or detach during use of the
Weigh Below feature. Failure to follow these
instructions could result in personal injury and
damage to the equipment.
To use this feature, remove power from the scale, then
remove the protective cover for the weigh below
opening (2 screws). (See Figures 92-93)
SERIAL COMMUNICATION AND COMPUTER/PRINTER SETUP

INTERFACE COMMANDS

The scale supports both MT-SICS and OHAUS commands. Commands listed in the following tables will be
acknowledged by the scale. To use the MT-SICS commands, send the command PSI. To return to the OHAUS
commands, send the command POH. SICS commands can also be active in the menu setup.
OHAUS COMMANDS
COMMAND
IP
P
CP
SP
xS
xP
Z
T
xT
PU
xU
xM
PSN
CU xxx
CO xxx
x#
P#
x%
P%
PV
H x "text"
\EscR
SNS x
PAGE 28 OF 105
OPERATION CONTINUED
Immediate Print of displayed weight (stable or unstable).
Print displayed weight (stable or unstable).
Continuous.
Print on Stability.
0S: Turn off "Stable Only" menu item and allow unstable print.
1S: Turn on "Stable Only" menu item and only print stable print.
Interval Print x = Print Interval (1-50,000 sec), 0P turns auto print OFF
Same as pressing Zero Key.
Same as pressing Tare Key.
Download Tare value in grams (positive values only).
Sending 0T clears tare (if allowed).
Print current unit: g, kg, lb, oz, lb:oz
Set scale to unit x: 1=kg, 2=lb, 3=g, 4=oz, 5=lb:oz
Set scale to mode x. 1=Weighing, 2=Counting, 3=Check, 4=Formulation, 5=Percent, 6=Filling,
7=Dynamic, 8=Density, 9=Differential. M will scroll to next enabled mode.
Print Serial Number.
Set Under Limit (only in Check mode) where "xxx" is the value under current unit.
Set Over Limit (only in Check mode) where "xxx" is the value under current unit.
Set Counting APW (x) in grams. (only in Counting or Check Counting mode, must have APW stored).
Print Counting or Check Counting mode APW.
Set Percent mode reference weight (x) in grams (must have reference weight stored).
Print Percent mode reference weight.
Version: print name, software revision and LFT ON (if LFT is set ON).
Enter String content, x = String number (1-10), "text" = string text up to 40 alphanumeric characters.
Global reset to reset all menu settings to the original factory defaults.
Switch the platform: x = 1, 2
Figure 92
With Cover
NOTE: The scale can be supported using lab
jacks or any other convenient method. Ensure
scale is level and secure. Power on, then use
an appropriate string or wire to attach items to
be weighed.
FUNCTION
Figure 93
Without Cover
0721 IH-7991