Setting The Operating Mode; Self-Calibration - Gima MAYLEA Instrucciones De Uso

Setting the operating mode

Setting the mode
Press key 1 to select the mode A,
B or C.
Set the mode A, B or C referring to the table below.
MODE A
mode A: the selected air chambers inflate and deflate independently in sequence from foot to thigh.
►
mode B: the selected air chambers inflate in sequence from foot to thigh and then all deflate at the
►
same time.
mode C: mode B is repeated for two times and mode A for one time, in reversed sequence (from thigh
►
to foot).

Self-Calibration

If you detect unusual conditions, press the keys MODE, SKIP and POWER at the same time.
You should perform a Self-calibration every six months to adjust the pressure.
Setting the SKP function
-
-
-
MODE B
Press key 1 to select a channel
(indicated by led 2).
Select the side or sides to be skipped
using the keys of timer 3.
Press once again key 1 to complete
the setup.
MODE C
X2 times
11