Storing The Machine; Storing The Battery; 10. Handling And Transportation; 11. Maintenance Table - ST CP1 430 Li 48 Serie Manual De Instrucciones

Do not touch the cutting means until the key has
been removed and the cutting means is completely sta-
tionary.
All operations on the cutting means (disassembly,
sharpening, balancing, repairing, reassembly and/or
replacing) are complex jobs that require special skills as
well as special tools; For safety reasons, these jobs are
best carried out at a Authorised Service Centre.
Make sure damaged, misshapen or worn cutting
means are replaced, together with the securing screws,
to preserve balance.
IMPORTANT Always use original cutting means bearing
the code indicated in the 'Technical Data" table.
Given product evolution, the cutting means listed in the
"Technical Data" table may be replaced in time with others
having similar interchangeable and operating safety fea-
tures.
9. STORAGE
9.1

STORING THE MACHINE

When the machine is to be stored away:
1. Wait for the engine to cool.
2. Remove the safety key.
3. Clean (par. 7.3).
4. Check the integrity of the machine.
5. Store the machine:
• In a dry place.
• Protected from inclement weather.
• In a place where children cannot get to it.

11. MAINTENANCE TABLE

MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear/lateral discharge guards;
Check the grass catcher bag and lateral discharge chute; Check the cutting means.
General cleaning and inspection; Checking for any damage to the machine. If nec-
essary, contact the authorised service centre.
Replacing the cutting means
Check the battery charge status
Recharge the battery
Cleaning the air filter
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
*** Operation to be performed at the first signs of any malfunction
Intervention
• Making sure that keys or tools used for maintenance are
removed.
9.2

STORING THE BATTERY

The battery must be kept in a cool, shaded place without
humidity.
NOTE In case of prolonged periods of inactivity, recharge
the battery every two months.

10. HANDLING AND TRANSPORTATION

Whenever the machine is to be handled, raised, transported
or tilted you must:
• Stop the machine (par.6.5) until the moving parts come to a
complete halt.
• Wear heavy duty gloves.
• Hold the machine in the points offering a safe grip, taking
into account the weight and its division.
• Use an appropriate number of people for the weight of the
machine and the characteristics of the vehicle or the place
where it must be placed or collected.
• Make sure that machine movements do not cause damage
or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and length.
• Load the machine with the motor switched off and pushed by
an adequate number of people.
• Lower the cutting means assembly.
• Position it so that it cannot cause a hazard for anybody.
• Fasten firmly to the means of transport using ropes or chains
to prevent it from tipping over.
EN - 9
Frequency
Before use par. 6.2
After each use par. 7.3
- par. 81 ***
Before each use
After each use par. 7.2.2 *
Once a month par. 7.5
Notes
*