Fein GRIT GIR Instrucciones De Uso página 12

GIR_GIRA - Buch Seite 12 Dienstag, 8. August 2006 11:37 11
EN
Symbols, abbreviations and
terms used.
The symbols used in this Instruction Manual and
where necessary on the machine, serve to draw
your attention to possible hazards when work-
ing with this machine.
Symbol Term, meaning
Action
General mandatory sign
Read documentation
Danger warning
European conformity symbol
For your safety.
Do not use this machine before you have
thoroughly read and completely under-
stood this Instruction Manual, including the fig-
ures, specifications and safety regulations.
Read and observe the Instruction Manuals
of the GI 150/GI 150 2H belt grinder as
well as the GIB/GIBE undercarriage that are to
be mounted to this machine.
This Instruction Manual should be kept for later
use and enclosed with the machine, should it be
passed on or sold.
Use only the fastening material provided for
mounting the radius grinding module to the belt
grinder. When mounted incorrectly, the radius
grinding module can loosen itself from the belt
grinder during the working procedure and lead
to serious injuries.
Use safety glasses. The safety glasses must
be capable of protecting against flying par-
ticles generated by the various different opera-
tions.
Make sure that all clamping levers and clamping
fixtures are firmly tightened. If the machine sud-
denly starts to lower itself or if the work piece
becomes loose during the working procedure,
serious injuries can result.
12
At a glance.
1 Cover/stop (GI 150/GI 150 2H)
2 Spark guard (GI 150/GI 150 2H)
3 Grinding rest (GI 150/GI 150 2H)
4 Dust collector (GI 150/GI 150 2H)
5 Side cover (GI 150/GI 150 2H)
6 Lever for swivel device (GIB/GIBE)
7 Counter-plate
8 Angled-plate
9 Bolts for angled-plate
10 Bolts for counter-plate
11 Belt tension lever (GI 150/GI 150 2H)
12 Mounting bolts for side assembly
13 "Centre height" adjustment lever
(pipe centre)
14 Automatic "Stop/EMERGENCY OFF" button
15 Clamping lever for "Centre height" adjustment
16 Automatic "Start" button
17 "Grinding depth/depth stop" adjustment
18 Crank for adjustment of work piece width
19 Collection receptacle
20 Work piece quick-clamping lever
21 Clamping jaws, fixed
22 "Working width" stop
23 Mounting bolts
24 Holding device/magazine for contact rollers
25 Star-knob bolt, height adjustment
26 Protective covers/side cover
27 Contact roller
28 Locking screw for contact roller
29 Clamping lever for angle adjustment
30 Mounting screws for alignment of radius
grinding module/belt grinder
31 Manometer
32 Speed "Worktable forwards" (factory set)
33 Speed "Worktable reverse" (factory set)
34 "Deburring" timer
35 Feed pressure adjustment
36 Compressed-air connection
GIR/GIRA