Changing The Torch Body - Water-Cooled Welding Torches - Fronius TTB 80 G Manual De Instrucciones

4
* Grease the O-ring before installation!
6
IMPORTANT! When installing the torch body, ensure that it is pushed all the way in and
snaps into place.
Changing the
1
torch body –
water-cooled wel-
ding torches
2
3
1
180°
*
180°
2
1
Switch off the power source and disconnect from the grid;
wait for the after-run phase of the cooling system
For a CU 600 MC cooling unit:
empty the torch hosepack using the power source or welding torch
For other cooling units:
disconnect the coolant supply hose from the cooling unit
Purge the coolant supply hose with max. 4 bar compressed air so that the majority of
the coolant flows back into the coolant container
5
1
7
57