Hach DR 6000 Manual Básico Del Usuario página 16

Plug the USB storage device into the USB A interface on the
1.
DR 6000 or connect the DR 6000 with a network drive.
Press Recall Data from the Main Menu.
2.
Select the data category to be transferred, e.g. Data Log.
3.
A list of the selected measurement data is displayed.
English 16
Tap on Options and then on the
4.
PC & Printer symbol.
Select the data to be sent.
5.
The following options are available:
Single point: only this selected reading will be sent
•
Filtered data: only readings that correspond to the set filters
•
will be sent
All data: all data in the selected data category will be sent.
•
Press OK to confirm.
6.
Note: The number in parentheses is the total number of data sets
assigned to this selection.