Hach DR 6000 Manual Básico Del Usuario página 6

The DR 6000 contains an RFID module for the reception and
transmission of information and data. The RFID module operates with a
frequency of 13.56 MHz.
WA R N I N G
The spectrophotometer may not be used in dangerous environments.
The manufacturer and its suppliers reject any express or indirect guarantee for
use with high-risk activities.
Follow the following safety information, in addition to any local guidelines
in force.
Safety information for the correct use of the instrument:
Do not operate the instrument in hospitals or comparable
•
establishments in the vicinity of medical equipment, such as pace
makers or hearing aids.
Do not operate the instrument near highly flammable substances,
•
such as fuels, highly combustible chemicals and explosives.
Do not operate the device near combustible gases, vapors or dust.
•
Do not vibrate or jolt the instrument.
•
The instrument can cause interference in immediate proximity to
•
televisions, radios and computers.
Do not open the instrument.
•
Guarantee is voided if the instrument is not used in accordance with
•
the guidelines present in this document.
Certification (integrated RFID module)
FCC ID: YUH-QR15HL
IC: 9278A-QR15HL
This device complies with Part 15 of the FCC rules and Industry Canada
license exempt RSS standard(s).
Operation is subject to the following two conditions:
this device may not cause interference, and
1.
this device must accept any interference, including interference that
2.
may cause undesired operation of the device.
English 6
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
l'appareil nedoit pas produire de brouillage, et
1.
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
2.
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be
required to correct the interference at their expense. The following
techniques can be used to reduce interference problems:
Disconnect the equipment from its power source to verify that it is
1.
or is not the source of the interference.
If the equipment is connected to the same outlet as the device
2.
experiencing interference, connect the equipment to a different
outlet.
Move the equipment away from the device receiving the
3.
interference.
Reposition the receiving antenna for the device receiving the
4.
interference.
Try combinations of the above.
5.