geberit ECO 201 Instrucciones De Servicio página 16

Function
1 Green LED
2 Red LED
3 Start button
4 Stop button (emergency
off)
Automatic pressing function
LED indicator
Stop button
Signal tone
16
Operating instructions ECO 201
1 2 3
An automatic pressing function ensures that the pressed joint is
completely finished. For safety reasons, the automatic pressing
function is not activated until a certain press capacity has been
attained (after approx. two seconds). Following this, the pressing
operation takes place automatically and can only be interrupted by
pressing the stop button.
The two LEDs show the operating statuses of the pressing tool. The
pressing tool is ready when the green LED is lit. The red LED
indicates a malfunction (see the "Troubleshooting" chapter).
The stop button has two functions:
• Switching off the motor
• Cancelling the malfunction indicator
A signal tone sounds six times in case of malfunctions or if the
pressing has not been completed correctly.
4