geberit ECO 201 Instrucciones De Servicio página 21

Interval
Every six months
Every year
Maintenance
Operating instructions ECO 201
Maintenance work
• Have an electrician or an authorised specialist workshop perform a
check and take measurements in order to establish any defects or
damage that could affect safety.
This check should include measuring the following values:
- Insulation resistance
- Dielectric strength
- Leakage current
- Contact current
However, this does not replace any specific national regulations and
legislation that might prescribe further checks and maintenance work.
• Have an authorised specialist workshop check the press capacity and
the state of wear
Clean and lubricate the pressing device
Prerequisites
Pressing device is switched off.
WARNING
Risk of injury by switching on inadvertently
` Unplug the mains connector before starting any
maintenance work on the tool
CAUTION
Damage to the device by moisture
` Never immerse the pressing device in water or other
liquids
1 Clean the roller drive and locking pin of the pressing device
2 Use compressed air or a brush to remove dirt
Use WD-40® or equivalent to lubricate the roller drive, its
3
guide and the locking pin
4
Wipe away excess grease
EN
21