Wiring Temperature Sensor To Transmitter - Siemens SITRANS F FUG1010 IP65 NEMA 4X Instrucciones De Operación

8. Replace access cover. Make sure Keypad Enable switch is in the "Enable" position (see
9. If installing a Temperature Sensor, go to Wiring Temperature Sensor to Transmitter
3.2.2

Wiring Temperature Sensor to Transmitter

Wiring Temperature Sensor to the Analog Input Module
Hazard Voltage
Contact with exposed wiring will lead to fire, electric shock, or serious personal injury.
Set transmitter and instrumentation power to OFF when inserting or removing the Analog
Input Module, or when making connections to TB1, TB2, TB3 and TB4.
1. Disconnect power from the unit to the transmitter.
2. Open the transmitter top cover by releasing the cover latch.
FUG1010 IP65 NEMA 4X Quick Start
Operating Instructions, 06/2014, A5E02951527-AC
below).
①
Enable Switch
(Page 21) below. If not, proceed to Navigating The Menu.
DANGER
Connecting
3.2 Transmitter Wiring
21