Sensor Installation; General Information - Siemens SITRANS F FUG1010 IP65 NEMA 4X Instrucciones De Operación

Connecting

3.5 Sensor Installation

Save/Rename Site procedure
Whenever new site configurations are added to an existing site that site must be saved again
to retain the new site changes. A "pop-up" prompt to save the site will appear to remind you
to save your changes.
1. At the pop-up prompt, press the <Right Arrow> and <ENTER> key to save all
programmed data.
2. An alternative method to save site data is found within the [Chan/Path] menu.
3. Scroll to [Chan/Path]. Press the <Right Arrow> and scroll to [Save/Rename Site].
4. Press the <Right Arrow> and then <ENTER> to save the site, or you may change the site
name before saving.
3.5 Sensor Installation
3.5.1

General Information

Reflect and Direct Mounting Modes
Reflect and Direct mounting modes are supported for clamp-on sensors. The transmitter
recommends a mounting mode after analyzing your pipe and gas data entries. This Quick
Start illustrates a typical sensor setup using the Reflect Mode.
Note
For Direct Mode refer to the Operating Instructions manual.
38
①
The saved site name now appears in the menu screen.
FUG1010 IP65 NEMA 4X Quick Start
Operating Instructions, 06/2014, A5E02951527-AC