Loading The Batteries; Error Warning; Auto Power Off - Sigma EF-630 Manual Del Usuario

LOADING THE BATTERIES

1. Turn the power switch to [OFF] and open the battery
compartment by sliding the cover. P.3-(1)
2. Follow the indication in the battery compartment and insert
the batteries with the "+" and "-" electrodes in the correct
direction. P.3-(2)
3. Close the battery compartment cover. P.3-(3)
4. Turn the power switch to [ON]. When the flashgun is charged
to the level that flash firing is possible, the Ready light starts
blinking in green. When the flashgun is fully charged, the
light lights up in red.
Caution!!
When the battery capacity gets low, the
mark is indicated on the LCD panel. When
the battery capacity decreases to zero, the
display indicates the mark on the right, and
the flash will no longer function. Please
replace the batteries.

ERROR WARNING

When the mark is indicated on the LCD panel, the flash
may have failures. Reset the power switch or check the battery.
If the indication remains, contact our sales office.

AUTO POWER OFF

To conserve battery power, the flash unit automatically turns
itself off when the flash has not been used for approximately 80
seconds. To turn the flash on again, depress the TEST button
or the camera shutter button halfway. However, the auto power
off does not work in [WL SLAVE] mode, [S-FL NORMAL]
mode and [S-FL SLAVE] mode.
ATTACHMENT TO THE CAMERA
1. Turn the power switch to [OFF].
2. Confirm that the shoe lock lever is in the [UNLOCK ►]
position. P.3-(4)
3. Insert the flash on to the hot shoe of the camera until it stops.
Slide the shoe lock lever to the [◄LOCK] direction until the
lever is locked with a clicking sound. P.3-(5)
When removing the flash, slide the shoe lock lever to the [UN
LOCK►] direction until it stops while continuing to press the
shoe lock lever button. Then pull out the flash.
Caution!!
If the flash is pulled out while the shoe lock lever is not in the
[UNLOCK►] position, the hot shoe of the camera and the
attachment shoe of the flash could be damaged.
ADJUSTING THE FLASH HEAD
In regular shooting, set the flash head to face forwards. P.3-(6)
Caution!!
After the power switch is turned to ON, if the
is indicated in the Status area, or if the distance indication in
the Status area is blinking, the flash head is not correctly set to
the front direction.
mark
21