Statement 1018-Supply Circuit; Statement 1019-Main Disconnecting Device; Statement 1021-Selv Circuit; Statement 1022-Disconnect Device - Cisco ASR 920 Serie Manual Del Usuario

Statement 1018—Supply Circuit
Warning Take care when connecting units to the supply circuit so that wiring is not overloaded.
Statement 1019—Main Disconnecting Device
Warning The plug-socket combination must be accessible at all times, because it serves as the main disconnecting device.
Statement 1021—SELV Circuit
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage
(TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports
both use RJ-45 connectors. Use caution when connecting cables.
Statement 1022—Disconnect Device
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Warning
Statement 1023—No. 26 AWG
To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
Warning
Statement 1024—Ground Conductor
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of
Warning
a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if
you are uncertain that suitable grounding is available.
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
8
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
OL-32476-01 Rev. V4