Statement 3023-Equipment That Complies With 47 Cfr Part 68; Statement 7003-Telcordia Gr-1089 Nebs Standard For Electromagnetic Compatibility And Safety; Statement 7005-Intra-Building Lightning Surge And Ac Power Fault - Cisco ASR 920 Serie Manual Del Usuario

Statement 3023—Equipment That Complies With 47 CFR Part 68
This equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. On the
bottom of the equipment is a label that contains, among other information, a product identifier in the format,
US:AAAEQ##TXXX. If requested, this number must be provided to the telephone company.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. If advance notice is not practical, the telephone
company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operation, or procedures that could
affect the operation of this equipment. If this happens, the telephone company will provide advance notice in
order for you to make the necessary modifications to maintain uninterrupted service.
If you have trouble with this equipment, please contact Cisco Systems for repair and warranty information.
If the trouble is causing harm to the telephone network, the telephone company can request that you remove
the equipment from the network until the problem is resolved. This equipment uses the Uniform Service Order
Code (USOC) jacks that are described below.
Statement 7003—Telcordia GR-1089 NEBS Standard for
Electromagnetic Compatibility and Safety
Warning The intra-building port(s) of the equipment or subassembly must use shielded intra-building cabling/wiring that
is grounded at both ends.
Statement 7005—Intra-building Lightning Surge and AC Power
Fault
Warning The intra-building port(s) of the equipment or subassembly must not be metallically connected to interfaces that
connect to the OSP or its wiring. These interfaces are designed for use as intra-building interfaces only (Type 2
or Type 4 ports as described in GR-1089-CORE) and require isolation from the exposed OSP cabling. The addition
of Primary Protectors is not sufficient protection in order to connect these interfaces metallically to OSP wiring.
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
14
Regulatory Compliance and Safety Information—Cisco ASR 920 Series Aggregation Services Routers
OL-32476-01 Rev. V4