Roger Technology AG/CTRL AGILIK Instrucciones Y Advertencias Para El Instalador página 38

h0 01
Operating hours
h1 23
The number of operating hours is obtained by combining the values of the parameters
example in this table are indicated the values (next to the parameters, are not default values) from which is
obtained the number
d0 01
Number of days in which the control unit was on
d1 23
The number of days in which the control unit was on is obtained by combining the values of the parameters
d0 d1
up to . For example in this table are indicated the values (next to the parameters, are not default
values) from which is obtained the number
P1 00
P2 00
Password
P3 00
P4 00
CP 00
Password change
Storing a password enables the protection of data in memory, allowing only those who know it to change its
value. The password entering procedure is the following:
• enter the eight numbers that form the password in parameters
• view on display the parameter
display flashes, the new setting has been saved.
The protection will be immediately activated after restarting the control unit or after 30 minutes of standby.
WARNING! When the password protection is active, the keys + and - do not allow changing the value of a
certain parameter and parameter
Parameters unlocking procedure (temporary): enter in parameters
stored password, then view on display the parameter
disabled).
The password can be removed only by someone who knows it, proceeding as follows: enter the password,
p1 00
store the password
If the password is forgotten, the control unit can be unlocked by contacting the technical support.
38
01 23
, that are 123 operating hours.
CP
: press at the same time the keys + and - for 4 seconds. When the
CP
is set to
p2 00 p3 00
, ,
01 23
, that are 123 days in which the control unit was on.
01
.
CP
and make sure that its value is
p4 00
, , and confirm it with parameter
p1 p2 p3 P4
, , and
p1 p2 p3
, , and
CP
h0 h1
up to . For
P4
the previously
00
(protection
.