Trouble-Shooting - Brill Electro 380 Manual Del Usuario

10. Trouble-shooting

The following table contains the problems most frequently occurring and shows how to remedy them.
Problem
Abnormal noise.
Clattering in the unit.
Metal-like hammering noises.
Schlaggeräusche.
Overload clutch activated.
Yellow lawn.
Cut not clean.
If you have any other problems
with your Electric Lawnmower,
please contact Brill Customer
Service or return the defective
unit with a short description of
the problem and, in case of
guarantee, with the appropriate
guarantee documents to one of
the service centres listed in this
leaflet.
Possible cause
Motor fixing screws or
mower casing loose.
Cutting cylinder touches
the bottom blade.
Foreign body blocking the
cutting cylinder.
Cutting cylinder deformed
by foreign object.
Blocked by foreign body.
The clutch has therefore
been activated.
Clutch has been activated.
The cutting height you have
selected is too low; you are
pushing the mower too quickly.
Coupling/circuit breaker has
been activated.
Cutting height too low.
Cutting gap between cutting
cylinder and bottom blade
is too wide.
Blades are blunt or damaged.
We would draw attention to
the fact that, under the product
liability legislation, we are not
liable for loss or damage caused
by our products when such are
caused by improper repairs or
when during an exchange of
parts such parts are used which
Remedy
Tighten screws.
Adjust or replace if damaged.
Turn off the mower.
Disconnect the mains plug.
Remove the foreign body.
Install a new cutting cylinder .
Switch off the motor.
Disconnect the mains plug.
Remove the foreign body.
First use your Electric Hand
Lawnmower with a higher
cutting height, then reduce the
cutting height in stages until you
reach the lower cutting height
you require.
Push the mower more slowly
across the lawn.
Increase the cutting height.
Readjust cutting tool (refer to
section 8.2.).
Have the blade replaced at a
Brill Service Centre or by an
authorised specialist.
are not manufactured by or ap-
proved by ourselves, and the re-
pairs are not carried out by an
authorised Brill service centre or
an authorised specialist dealer.
The same restrictions also apply
for supplementary and accessory
parts.
GB
25