Electrical Installation - SICK GRSE18V Instrucciones De Operación

5

Electrical installation

8021182.16B5 | SICK
Subject to change without notice
max. 90 Nm
Note the sensor's maximum permissible tightening torque of 90 Nm.
NOTE
Swap the sender and receiver arrangement at every second photoelectric through-
beam sensor and ensure that there is sufficient distance between the through-beam
photoelectric sensors.
Sender (GS)
Receiver (GE)
Sender (GS)
Figure 10: Arrangement of several through-beam photoelectric sensors
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established. The green LED indicator lights up on the sensor.
Explanations of the connection diagram (Tables 2 and 3):
Q / Q = switching outputs
TI / Test = test input (see table
n. c. = not connected
ELECTRICAL INSTALLATION
> 0 V) once all electrical connec‐
V
5)
Receiver (GE)
Sender (GS)
Receiver (GE)
= 0 V). The following informa‐
V
5
7