Equipment Setup And Use; Prior To Use; Setup - AMATECH F-AHTMAQ3 Manual De Instrucciones

INSTRUCTIONS FOR USE
3

Equipment Setup and Use:

3.1 Prior to use:

a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.

3.2 Setup:

TO INSTALL:
a. Tilt the table up approximately
30° and hook the upper jaw of
the clamps over the table rail.
b. Once the clamps are hooked
over the table rail lower the Arm
& Hand Table back to a
horizontal position.
NOTE:
If the table does not lower to a horizontal position, please refer to Adjustment
Instructions or contact your Maquet Service Representative for assistance.
Document Number: 80028303
Version: B
Page 12
Issue Date: 27 MAR 2020
Ref Blank Template: 80025118 Ver. E