Hilti PR 30-HVSG A12 Manual De Instrucciones página 47

Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The tool doesn't work.
The battery runs down more
quickly than usual.
The battery doesn't engage
with an audible click.
The tool or battery gets very
hot.
Serious error. All the LEDs on
the rotating laser flash.
Warning
Pairing was unsuccessful.
Pairing was unsuccessful.
*2179602*
Possible cause
The battery is not fully inserted.
Low battery.
The tool has a fault or error.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
Serious error. This message is al-
ways accompanied by the corre-
sponding symbol.
The warning message is always
accompanied by the correspond-
ing symbol.
Pairing the rotating laser and laser
receiver is not possible.
Pairing the tripod and laser re-
ceiver is not possible.
2179602
Action to be taken
▶ Push the battery in until it
engages with an audible click.
▶ Change the battery and charge
the empty battery.
▶ Switch the tool off and then on
again. Contact Hilti Service if
the fault / error persists.
▶ Warm up the battery slowly to
room temperature.
▶ Clean the retaining lugs and refit
the battery.
▶ Switch the tool off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
▶ Further operation is not possi-
ble. Switch off all tools / devices
and then switch them on again.
▶ Solutions are indicated by the
corresponding symbol.
▶ Follow the instructions on
pairing the devices exactly.
▶ Pair the rotating laser and the
laser receiver. → page 34
▶ Follow the instructions on
pairing the devices exactly.
▶ Pair the tripod and laser
receiver. → page 34
English 39