Switching Off Beam Segments; Pairing Accessories And Device; Led Indicators; Li-Ion Battery Charge State Display - Hilti PR 30-HVSG A12 Manual De Instrucciones

The sensitivity of the shock warning function can be set using the PRA 30G laser receiver.
The shock warning function can be switched off by pressing the
from vibration or when you are working in inclined plane mode.
▶ Deactivate the shock warning function. → page 33
3.9 Sleep mode
Sleep mode may be activated on the rotating laser during breaks between work or during other activities. All
settings concerning the laser plane or inclination are retained while in this status. Sleep mode saves power
and extends battery life.
PRA 30G the laser receiver is used to activate / deactivate sleep mode.
Sleep mode remains active for a maximum of 4 hours. The system switches itself off after this time.
3.10

Switching off beam segments

Individual segments of the path of the laser beam can be deactivated in order to:
• Avoid exposing yourself or bystanders to the laser beam.
• Avoid influencing other measuring or alignment work being carried out in the vicinity.
3.11 Laser receiver / remote control unit
Hilti laser receivers digitally indicate the distance between the marking notch on the laser receiver and the
position at which the laser beam (laser plane) strikes the detection area on the receiver. The laser beam can
also be received over long distances. The PRA 30G can be used as a laser receiver and also as a remote
control unit for the rotating laser.
3.12

Pairing accessories and device

Pairing accessories and device
Pairing is the act of enabling accessories and devices to communicate with each other by wireless.
The rotating laser and the laser receiver are already paired when supplied. This helps ensure trouble-free
operation within the vicinity of other wireless devices.
Additional laser receivers or PRA 90 automatic tripods cannot be used without first being paired.
▶ Pair the rotating laser and the laser receiver. → page 34
▶ Pair the tripod and laser receiver. → page 34
3.13

LED indicators

The rotating laser is equipped with LED indicators.
Status
All LEDs blink.
The auto-leveling LED flashes green.
The auto-leveling LED shows steady green.
The shock warning LED shows steady orange.
The inclination LED shows steady orange
The surveillance LED flashes orange.
The surveillance mode LED shows steady orange.
3.14

Li-ion battery charge state display

The Li-ion battery features a state of charge display.
Status
4 LEDs light.
*2179602*
Meaning
The tool has been bumped, knocked off level or
has a fault.
The tool is in the leveling phase.
The tool has leveled itself / is operating normally.
Shock warning mode is deactivated.
Inclined plane mode is active.
The tool is aligning the laser plane with the
(PRA 30G) reference point.
The tool is in surveillance mode. Alignment with the
reference point (PRA 30G) is correct.
Meaning
Charge status: 75 % to 100 %
2179602
button if the ground or floor is not free
English 27