Eaton Powerware 5125 Guia De Instalacion página 43

If you press the On button and nothing happens, the UPS is still in
Operation mode. Repeat Step 1 to enter Configuration mode, and
then perform Step 2.
3. Press the Off
Repeat Steps 2 and 3 for each option. Scrolling past the last
indicator returns to the first configuration option.
NOTE The UPS exits Configuration mode automatically after two minutes of inactivity.
4. Press the
mode. If you do not press the
original settings.
Press the On and Alarm Reset buttons
simultaneously to enter Configuration
mode.
Configuration Mode Indicators
Figure 24. Using Configuration Mode
®
EATON Powerware 5125 (9910-P65) UPS Installation Guide for IBM
button ONCE to select the option.
button to confirm the selection and exit Configuration
button, the UPS defaults to the
1
3
Press the Off button ONCE to
toggle an option on or off.
®
Applications
OPERATION
2
Press the On button to
scroll to the next option.
On Button
Off Button
Alarm Reset Button
4
Press the Alarm Reset
button to save the setting
and exit Configuration
mode.
S
164201638 Rev A
29