Setup And Installation; Rack-Mount Setup - Eaton Powerware 5125 Guia De Instalacion

INSTALLATION

Setup and Installation

The P65 UPS can be purchased separately or factory-installed in an IBM
iSeries or pSeries rack.
NOTE If the UPS is pre-installed in an IBM rack, continue to "Installing the Internal
Batteries" on page 12. If you are installing the UPS in an IBM iSeries (0550, 0551, or 0553
type) or pSeries (7014 type) rack, continue to the following section, "Rack-Mount Setup."

Rack-Mount Setup

The rail kit can be mounted in 19-inch panel racks from 24 to 30 inches
deep.
NOTE Mounting rails are required for each individual cabinet. The UPS uses FC 6632 and
the EBM uses FC 6631.
NOTE If placing the P65 in a rack with existing equipment, the rack must be reconfigured
to install the heaviest item in the bottom of the rack. The UPS weighs 73 kg (161 lb) and the
EBM weighs 77.1 kg (170 lb).
Each rail kit requires one (1) of each item in the following list (supplied):
S
S
S
S
4
EATON Powerware
Left adjustable rail assembly
Right adjustable rail assembly
Rail hardware kit
Rack mounting bracket kit
®
5125 (9910-P65) UPS Installation Guide for IBM
® S
Applications 164201638 Rev A